How to setup your OSM2/OSM2.1 on Windows (Getting Started Full Video Tutorial)
Posted: Mon Aug 08, 2016 12:04 pm
Did you just get your OSM2 (or OSM2.1) and need a tutorial on how to set them up? Never setup the OSM before? Want to go through the initial setup process again? Well you're in luck, below you will find a full video tutorial I put together on how to setup your OSM from start to finish, using the default NEO firmware.
This video tutorial covers these steps:
Latest NEO Firmware Download:
viewtopic.php?f=20&t=8
Windows USB Programmer Cable Driver Download:
http://osf.guru/viewtopic.php?f=31&t=32
Arduino 1.6.5 for Windows Download:
http://osf.guru/viewtopic.php?f=31&t=35
This video tutorial covers these steps:
- Installing USB Programmer Cable Driver
- Installing Arduino 1.6.5
- Configuring Arduino 1.6.5
- Selecting the correct Board in Arduino
- Configuring, selecting, and determining the correct COM port to set in Arudino
- Uploading the NEO firmware to your OSM
Latest NEO Firmware Download:
viewtopic.php?f=20&t=8
Windows USB Programmer Cable Driver Download:
http://osf.guru/viewtopic.php?f=31&t=32
Arduino 1.6.5 for Windows Download:
http://osf.guru/viewtopic.php?f=31&t=35